IM2021
17
Automatically reduce the display brightness
When the lighting of the room changing, the display brightness automatically decreases within a few seconds
after the last button press on the control panel. When you press the buttons, the display brightness
automatically increases.
Automatic switching off when there is no water
When water level in the tank drops below minimal level, the ultrasonic membrane will automatically switch
off, and the water indicator will light up on the display
. To continue operation of the appliance it is
necessary to fill the tank with water according to «Filling the water tank» paragraph, and then connect the
appliance to the electric mains.
Turning off the device
To turn off the device, press the "POWER/SLEEP" button on the control panel and disconnect the device
from the electrical network.
Adjusting the humidity level
Tap the "HYGRO" button to set the desired humidity level (40-90% relative humidity). The measurement
accuracy is +/- 5%. The device will switch to normal mode when the humidity level exceeds the desired
setting. When you select the humidity level, the display will automatically display the current value for a few
seconds.
ATTENTION!
If a large amount of condensate is generated on the upper part of the appliance when it is operating, then
you need to decrease the steam outlet intensity by turning on/off and steam outlet intensity knob
counterclockwise.
9.
CLEANING AND MAINTENANCE
Before cleaning the appliance, make sure it is unplugged. Otherwise, it may result in electric shock.
Before cleaning, in order not to burn your hands, wait until the water in the base of the appliance has
completely cooled.
Use a damp and soft cloth to wipe the outside of the appliance.
To avoid electric shock, do not scratch or damage the components of the device when cleaning.
Do not use solvent, gasoline, dimethylbenzene, hard brush, talcum powder and other substances when
cleaning the device.
Wipe off any remaining water inside the base of the unit under the tank with a damp and soft cloth.
To remove water on small parts, you can use a brush and then wipe them again with a soft cloth.
Clean the device once or twice a week.
If dirt is formed on the membrane, clean it with a brush.
Rinse the water tank cover and nozzle carefully and effortlessly with fresh water, otherwise this will
cause water to leak through the cover.
After removing any remaining water from the surface of nozzle, wipe it with a soft cloth.
Clean the outside of the appliance with a damp and soft cloth.
IMPORTANT!
To avoid deformation of working surfaces, resulting in decreased atomizing or other malfunctions, do
not use metallic brushes, blades or talc powder to wipe the atomizer’s surface.
The water tank may leak after heavy impacts.
In case of water leakage, immediately stop using the unit and contact an authorized service center.
To keep the unit dry, wipe the water after cleaning and dry the unit’s base and water tank. Make sure
that there is no water left inside the unit’s base and water tank.
Before a long break in use, dry the base and the tank, but the tank on the base and pack the device in a
plastic bag, then put it in a box.
Store the unit in a low-humidity room.
Storing the unit undried results in generation of mold.
