IM2021
18
10.
TROUBLESHOOTING
Malfunction
Possible cause
Solution
Poor atomizing (insufficient
productivity)
The unit is operating in
the low atomizing mode (low
atomizing frequency)
It is not a malfunction. Switch the
device into the intensive mode of
operation
The atomizer is clogged
Clean the atomizer.
Temperature of water in the
tank is low
Set maximum productivity mode.
The humidifier’s productivity will
go up after a while.
No atomizing
The power cord is poorly
connected to the outlet
Connect the power cord into
the outlet carefully
There is white patches from the
water on objects around the
humidifier (salts, separating out
from water)
White patches have
formed on the membrane
Clean the humidifier’s membrane
with a special brush
There is a lot of salts in the water
(calcium and magnesium)
Use filtered water
Steam has a bad smell
Stale water is used
Clean the unit according to
the cleaning and servicing
instructions and fill the tank
with fresh and filtered water
Remains of stale water or waste
have
accumulated in the unit’s
case or the atomizer
During the operation of the
device, condensate is forming on
the upper part of the humidifier
and on surrounding objects
High humidification intensity is
set.
Decrease the humidification
intensity
Room humidity and
room temperature are high
During the operation of the device
water appears next to it
High humidification intensity is
set.
Decrease the humidification
intensity
The water tank is badly installed
on the unit’s base and there is a
gap between them.
Turn off the unit and make sure
the
water
tank
is
installed
correctly on the base, without any
gaps between the tank and the
base.
White patches have formed on
the membrane and in grooves for
water (in the unit’s base).
Clean the unit according to the
cleaning
and
servicing
instructions.
Water appears next to the
humidifier, when it is off
Water tank is leaking
Contact an
authorized service center
11.
STORAGE
Before storage make sure that the appliance is disconnected from power source.
Perform all actions described in "CLEANING AND MAINTENANCE" section.
Wash and dry the appliance, place it in the original package and store in a dry place.
12.
UTILIZATION RULES
After the lifetime of the device expires, it should be recycled in compliance with the laws, rules and methods
in region of recycling. Detailed information about the recycling of the device, you can receive from a
representative of the local authorities, after providing full information about the device. The manufacturer and
authorized organization of the manufacturer do not carry responsibility for the fulfillment by the Buyer of the
requirements of legislation on utilization and methods of utilization of the device selected by the Buyer. The
lifetime of the device is indicated in the warranty card. Warranty period for the device and warranty terms are
specified in the warranty card. The warranty card is an integral part of the documentation supplied with this
unit. If there is no warranty card in the delivery set, ask for it from the Seller. The warranty card provided by
the Seller must conform to the manufacturer’s form.
