Disconnect the battery negative (-) terminal cable.
Remove the glove box.
Disconnect the PAB module connector.
Remove the crash pad assy and then the PAB module.
CAUTION
1.
Never attempt to disassemble or repair the air bag module or clock spring.
2.
Do not drop the air bag module or allow contact with water, grease or oil. Replace
it if a dent, crack, deformation or rust are detected.
3.
The air bag module should be stored on a flat surface and placed so that the pad
surface is facing upward. Do not place anything on top of it.
4.
Do not expose the air bag module to temperature over 93°C (200°F)
5.
An undeployed air bag module should only be disposed in accordance with the
procedures
6.
Never attempt to measure the circuit resistance of the air bag module (squib) even
if you are using the specified tester. If the circuit resistance is measured with a
tester, accidental air bag deployment will result in serious personal injury.
7.
Whenever the PAB is deployed, it should be replaced with a new one assembled
with an extension wire. Because the squib is melt down if the PAB is deployed
making the extension wire useless.
CAUTION
Wait at least 30 seconds.
Summary of Contents for 2001 Tiburon
