22
ROTATIONS
Rotations allows the user to turn a fastener under resistance through a specific
number of rotations; for example to turn a valve 20 revolutions clockwise. The
capacity of the rotations feature is 99.9 rotations. The rotations feature allows
the user to adjust the resolution to the nearest tenth of a rotation.
•
Pull and Hold the Trigger
– If tool is set to RH or LH Fastener, a message
instructs the user to press any button to start, in order to ensure that hands
are kept clear of the reaction arm.
•
Continue Holding -
The tool will rotate the nut/bolt until completing the
specified number of Rotations. When the trigger is pulled the Rotations
Function is highlighted yellow. Continue holding trigger if applying Release.
•
Hold for Release -
Continue holding the trigger if a non-zero Release has
been specified and the tool will restart (after specified time delay) and then
stop again after completing the Release angle to allow the tool to be released
from the nut.
NOTE:
If torque has been applied without a Release angle and the tool locks
onto the nut, loosen the nut, set a Release angle and try tightening again.
•
Monitor Screen and Status LED
- The status light is amber during operation.
If the operation is successful the status light will illuminate green. If
unsuccessful the status light will turn red. The final screen displayed will have
a green check mark. If unsuccessful the final screen will have a red X and the
operator will need to trouble shoot and/or try again.
•
Release Trigger
- Release the trigger after the tool has completed all
specified operations (Torque, Angle & Release), the tool stalls for the last
time and the Beeper sounds (if activated). Remove the tool socket/drive from
the nut.
(CONT ’ D.)
