14
•
Adjust Tool Parameters
– Select the desired configuration including Torque and Fastener and optionally
Angle and Release.
•
Rundown
–
Thread the nut onto the stud until positioned tight against the flange. When using the tool to run down the
nut set the speed control to “RUNDOWN” and position the tool on the nut – pull the trigger to quickly run down the nut
until it touches against the flange. When finished, set the speed control switch to TORQUE.
•
Position Back Wrench
-
If needed, apply a back wrench to the back nut on the bolt to prevent it from turning during
tightening. If using the HYTORC Back Washer a back wrench is unnecessary.
•
Position Drive/Socket
-
Place socket over nut until firmly engaged. If using the HYTORC Washer or HYTORC Nut, make
sure the driver properly engages the fastener.
•
Position Reaction Arm
-
If a reaction arm is used, make sure it is firmly abutted against a stationary object (e.g. an
adjacent nut, flange, equipment housing etc.).
BASIC BOLTING SETUP
(CONT ’ D.)
(CONT ’ D.)
