43
HYPRO WATER – 05.2021
43
When the red LED flashes or lights up, this
means one or more faults are present.
In order to better analyse faults, we
recommend installing the HYPRO APP.
Possible faults are described as per the
following:
Description of the fault.
– Possible cause.
y
Remedy.
The right LED flashes red.
– No filter in the device.
y
Fit an original filter.
– Filter expired.
y
Change the filter.
➡
“6.1 Changing the filter”
(page 41).
The right LED lights up red continuously.
– Device has a fault.
y
Unplug the power plug.
y
Wait for 15 seconds.
y
Put the device back into operation.
y
Open the disinfected water tap and
allow the water to run for at least
180 seconds.
If the fault persists:
y
Consult the HYPRO app for further
details.
y
Contact the customer service centre.
The left LED does not light up blue,
although water is flowing.
– Device has a fault.
y
Unplug the power plug.
y
Wait for 15 seconds.
y
Put the device back into operation.
y
Open the disinfected water tap and
allow the water to run for at least
180 seconds.
If the fault persists:
y
Consult the HYPRO app for further
details.
y
Contact the customer service centre.
The middle LED flashes yellow for lo
n
ger
than 5 minutes.
– The device is registered in the app but
is not connected with the WLAN.
y
Make sure the device is able to receive
the signal from the WLAN router.
No water flows out of the drinking water
tap.
– The shut-off valve on the T-piece (K)
has not been opened.
y
Open the shut-off valve of the
T-piece (K).
➡
“3.12 / 2” (page 37).
– Incorrect handling.
y
Check that the installation has been
carried out correctly, in accordance with
the user manual.
y
Check that the water connections and
disinfected water tap are open.
y
Check that the power plug is plugged
in.
7.
Troubleshooting
Summary of Contents for HYPRO WATER
Page 1: ...User manual HYPRO WATER EN 05 2021 ...
Page 52: ...05 2021 ...