Figure 11. Key Switch (Toggle Type)
Figure 12. Key Switch
INSTALL
Toggle switches may be used in place of key
switches certain applications. The term "key
switch" will be used for both types of switch in the
following instructions. See Figure 11 or Figure 12.
1.
Connect wires to proper terminals, as identified
during removal.
2.
Position the key switch through mounting hole
in dash and adjust switch to proper height by
turning lower jam nut.
3.
Install retaining nut to the key switch. Make
certain switch is properly aligned by referenc-
ing label before tightening retaining nut.
4.
Connect wiring to ignition switch and dash dis-
play.
5.
Using three capscrews, install dash display
onto frame mount.
6.
Connect battery and test the key switch by
turning it to the ON and OFF positions. Check
for proper operation.
7.
Install drive unit compartment covers. See Pe-
riodic Maintenance 8000SRM1635.
Parking Brake Switch
REMOVE
For the following procedures, see Figure 13.
1.
Move lift truck to a safe area and block drive
wheel to prevent unexpected movement.
2.
Disconnect battery and turn the key switch to
the OFF position.
3.
Remove drive unit compartment covers. See
Periodic Maintenance 8000SRM1635
4.
Discharge the capacitor. See Special Precau-
tions in this section.
NOTE:
Make note of the orientation of the parking
brake switch for proper installation.
5.
Remove retaining nut from top of parking
brake switch.
6.
Remove parking brake switch from mounting
hole in frame.
7.
Tag and identify all wires and connections for
reference during reassembly. Disconnect wires
from switch.
2200 SRM 1632
Key Switch
15
