Hyster T5ZAC, Service & Repair Manual

Page: 24 / 25

1. COVER
2. SCREW
3. LOCKWASHER
4. NAMEPLATE
5. BASE
6. SCREW
7. LOCKWASHER
8. INSULATION
9. SWITCH
10. ACTUATOR PLATE
11. ACTUATOR
12. SPRING
13. SCREW
14. SCREW
15. CABLE CLAMP
16. WHITE WIRE
17. SCREW
18. LOCKWASHER
19. GROUND SCREW
20. BLACK WIRE
Figure 14. Foot Switch
INSTALL
1.
Pull wires through rubber grommet in bottom
of base. Install wires to switch as removed. See
Figure 14.
2.
Install the screws (6) and lockwashers (7) se-
curing the wiring harness to the switch as re-
moved.
3.
Install actuator to actuator plate in the orienta-
tion shown.
4.
Attach actuator and actuator plate to switch by
inserting screws (14).
5.
Place switch assembly into base as removed.
6.
Center the spring inside the base between the
curved side and the actuator.
7.
Pull the switch toward the spring to align
screws with holes in base and tighten to secure
in place.
8.
Secure the switch assembly to the floor of the
operator's compartment using screws (17) and
lockwashers (18).
9.
Secure top cover to base using screws (2) and
lockwashers (3).
10.
Connect the battery and turn the key switch to
the ON position.
WARNING
Move the truck to an area with plenty of room
where top speeds can be checked safely.
11.
Test the high speed switch for proper operation.
12.
Install the floor mat.
High Speed Switch Assembly 2200 SRM 1632
18