Table 2. Input Connector A (Continued)
16 Pin Connector A
A13
AI4
Fourth Analog Input
A14
+BATT
+Battery, Short Circuit to
CNB#5
A15
COMMON
Positive of all the Digital
Inputs
Common Microswitch
A16
-BATT
-Battery
Battery Negative
Table 3. Input Connector B
6 Pin Connector B
B1
CAN LOW
Low Level CAN-BUS Voltage I/O
B2
-BATT
-Battery
B3
+KEY
Key Input
B4
CAN HIGH
High Level CAN-BUS Voltage I/O
B5
+BATT
+Battery, Short Circuit to CNA#14
B6
SAS
Internal Connected to DI1 With a
100 Ohm Resistance
Table 4. Input Connector C
8 Pin Connector C
C1
DI9
Ninth Digital Input
Tilt Up
C2
AI1
First Analog Input
C3
NPOT
Negative of Analog Input
C4
DI10
Tenth Digital Input
Tilt Down
C5
DI14
Fourteenth Digital Input Reach Out
C6
DI11
Eleventh Digital Input
Side Left
C7
DI12 / AI5
Twelfth Digital Input /
Fifth Analog Input
Side Right
C8
DI13 / AI6
Thirteenth Digital Input /
Sixth Analog Input
Reach In
Remove
1.
Turn the key switch to the OFF position and
disconnect the battery.
2.
Remove drive unit compartment covers for ac-
cess to the electrical components. See the sec-
tion Periodic Maintenance 8000SRM1635.
3.
Discharge the capacitors. See Discharging the
Capacitors in this section.
4.
Disconnect all connectors from the control mod-
ule.
5.
Remove capscrews, lock nuts, and washers se-
curing control module to the frame. See Fig-
ure 8.
Repairs
2200 SRM 1632
12
