Direction Control Switch
Remove
1.
Read and follow WARNING and CAUTION
section in General section above.
2.
Remove armrest from armrest mounting
bracket. Remove bottom armrest cover. See sec-
tion Armrest Assembly for removal procedures.
3.
Remove Direction Control Switch (DCS) assem-
bly from armrest by compressing clips on either
side of bezel and carefully pulling assembly out.
Disconnect E-Hydraulic control wiring harness
from DCS. See Figure 22.
4.
Remove DCS from bezel. See Figure 22.
Install
1.
Insert new DCS into bezel. See Figure 22.
2.
Connect E-Hydraulic control valve wiring har-
ness to DCS. Install DCS assembly into arm-
rest by compressing clips on either side of bezel
and pushing assembly into armrest until clips
latch. See Figure 22.
3.
Install armrest cover to armrest, and install
armrest to armrest mounting bracket. See sec-
tion Armrest Assembly for installation proce-
dures.
1. DIRECTION CONTROL SWITCH
2. BEZEL
3. ARMREST
4. E-HYDRAULIC CONTROL VALVE WIRING HAR-
NESS
Figure 22. Direction Control Switch Replacement
Emergency Disconnect Switch
Both E-Hydraulic controls and manual hydraulic
controls use the same emergency disconnect switch.
See Figure 23.
1. HORN BUTTON
2. EMERGENCY DISCONNECT SWITCH
3. DIRECTION CONTROL SWITCH
Figure 23. Emergency Disconnect Switch
Location, E-Hydraulic Controls
Remove
1.
Read and follow WARNING and CAUTION
section in General section above.
2.
Remove armrest from armrest mounting
bracket. Remove bottom armrest and PCB cas-
sette. See section Armrest Assembly for re-
moval procedures.
3.
Disconnect wires from emergency disconnect
switch.
Electronic and Manual Hydraulic Controls
2200 SRM 1524
18