Display Panel and Key or Keyless Switch Replacement
DISPLAY PANEL, REPLACE
Remove
WARNING
Before replacing the display panel, fully lower all
parts of the mast and tilt it forward until the tips of
the forks touch the ground. This action will pre-
vent the mast from lowering suddenly if the con-
trol lever is accidently moved.
WARNING
Disconnect the battery before doing any work on
the electrical system. Serious injury to personnel
and/or damage to lift truck components can occur
if battery is not disconnected.
Discharge capacitors as directed in Discharging
the Capacitors in General section of this manual.
CAUTION
A short circuit and damage can occur if wires are
not installed correctly. Make sure wire connectors
do not touch the other meter terminals or wire
connectors, metal brackets, or the bracket mount-
ing nuts. Make sure the wires are not pulled tight
and are not touching other parts to damage the in-
sulation.
NOTE:
The display panel cannot be repaired and
must be replaced as a unit, if it has a malfunction.
See the Parts Manual for replacement part num-
ber. The key or keyless switch can be replaced with-
out replacing the whole display panel.
The display panel is mounted inside of a display
panel cover. The display panel cover is mounted to
a bracket on upper right corner of overhead guard.
See Figure 1.
NOTE:
STANDARD KEY SWITCH SHOWN.
1. OVERHEAD GUARD
2. DISPLAY PANEL
3. DISPLAY PANEL COVER
4. KEY OR KEYLESS SWITCH
5. SLOT
Figure 1. Display Panel Arrangement
1.
Read and follow the WARNING and CAU-
TION above.
2.
Insert a flat head screwdriver in slot on bottom
of display panel. See Figure 1.
3.
Pull screwdriver down to loosen display panel
from slot. When display panel is loose from slot,
pull display panel out of the display panel
cover. See Figure 2.
2200 SRM 1524
Display Panel and Key or Keyless Switch Replacement
3
