HYOSUNG TE450 -, Manual

Page: 18 / 100

18
③③
TURN SIGNAL INDICATOR LAMP
When the turn signals are being operated
either to the right or to the left, the indicator
will flash at the same time.
④④
HIGH BEAM INDICATOR LAMP
The high beam indicator lamp will come
on when the head lamp high beam is turned
on.
⑤⑤
REVERSE INDICATOR LAMP
The reverse indicator lamp will come on
when the transmission is in reverse gear.
⑥⑥
NEUTRAL INDICATOR LAMP
The neutral indicator lamp will come on
when the transmission is in neutral.
The lamp will go out when you shift into
any gear other than neutral.
⑦⑦
ODOMETER / TRIP METER / CLOCK
The display in it has three functions,
odometer, trip meter and clock.
The display changes odometer, trip meter
or clock, as indicated before turning the
ignition switch off.
When the fuel indicator lamp comes
on, you should add fuel to the fuel
tank at the first opportunity to avoid
running out of fuel.
CAUTION
For checking the fuel indicator lamp,
hold the ATV horizontally and the
ignition switch “ ” (ON).
CAUTION
The lack of fuel will go off suddenly.
Failure to observe this precaution may
result in loss of control and an accident.
CAUTION
N O T E
● ●
High engine speed, low vehicle
speeds, or heavy load can increase
engine coolant temperature.
Decrease engine speed, reduce
load and select an appropriate
transmission gear to lower the
temperature.
● ●
Debris or mud in front of the engine
or packed between the radiator fins
can reduce cooling ability.
Remove any debris or mud
preventing air flow to the engine.
②②
FUEL INDICATOR LAMP
The fuel indicator lamp will come on when
the fuel drop below approximately 1.2
ℓ
.
Check if the remaining gasoline is enough
for running to the destination.
Fill the fuel tank before the indicator lamp lit.
The fuel tank capacity is 8
ℓ
.
Operating the ATV while the coolant
temperature indicator lamp is lit can
damage your ATV.
Continued operation of the ATV with
high engine coolant temperature may
result in engine damage or premature
wear.
If the coolant temperature indicator
lamp comes on, stop the engine and
allow it to cool before restarting.
Refer to the note below.
CAUTION