HYOSUNG ST7, Owner'S Manual

Page: 61 / 90

WARNING
CAUTION
CAUTION
CAUTION
60
1. Remove the two screws
2. Remove the air cleaner cover .
To remove the air cleaner :
5. Clean the air cleaner element for the fol-
lowing :
1) When the air cleaner element clean
with the air gun, necessarily blow at
the inside by compressed air.
2) Carefully examine the air cleaner
element for tears during cleaning.
Replace it with a new one if it is torn.
3) Assemble the element completely or
damage severely the engine.
4) Be careful not to allow water to go
inside the air cleaner element.
Before and during the cleaning opera-
tion, inspect the element for tears.
A torn element must be replaced.
Be sure to put the element snugly and
correctly, so that no incoming air will
bypass it.
Remember, rapid wear of the piston
rings and cylinder bore is often caused
by a defective or poorly fitted the ele-
ment.
3. Remove the four screws of the air
cleaner element.
4. Remove the air cleaner element .
●
When the assembly of the air cleaner
element is not completely done,
dusts can go inside and damage
severely engine.
●
Be careful not to allow water to go
into the element while washing.
More frequent servicing may be per-
formed on the motorcycle that are used
under severe conditions, also clean the
air cleaner element when replacing the
oil to prevent damage of the engine.
Operating the engine without the air
cleaner element in place can be haz-
ardous.
Never run the engine without the air
cleaner element in place.
❶
❷
❸ ❸
❹