HYOSUNG ST7, Owner'S Manual

Page: 30 / 90

WARNING
CAUTION
CAUTION
CAUTION
29
●
Take off the starter switch right after
started.
● Do not engage the starting motor for
more than five seconds at a time as it
may overheat the wiring harness and
starting motor.
If the engine does not start after sever-
al attempts, check the fuel supply and
igintion system. (Refer for Page 79 )
In case of , if push the star-
ter switch before the needle of the
speedometer will turn once to the end
when the ignition switch is set to “ON”
position with the engine stopped, the
engine will be started badly.
If the engine does not start, turn the igni-
tion switch to the “OFF” position and
attempt to restart after 8 seconds so that
ISC (Idling Speed Control) solenoid is
initialized.
⑤ ⑤
STARTER SWITCH
Use this switch to operate the starting
motor.
With the ignition switch in the “ON” posi-
tion, the engine stop switch in the “ ”
position, and the transmission is in neutral,
squeeze the clutch lever and the side stand
up and push the starter switch to start the
engine.
When the ignition switch is set to “ON”
position with the engine stopped, the meter
lamp will come on and the needle of the
speedometer will turn once to the end as a
test of electric system operation.
Push the starter switch after the needle of
the speedometer turn back.
is equipped with the side
stand ignition interlock system.
If the transmission is in neutral or side
stand up, you can only start the engine
with pulling in the clutch lever.
This side stand ignition interlock system
prevents the motorcycle from being
started with side stand down.
Make sure that the side stand igintion
interlock system is working properly
before riding.
This motorcycle always comes on the
head lamp, position lamp, meter lamp,
tail lamp and license plate lamp when
the ignition switch was turned to the
“ON” position.