![background image](http://html1.mh-extra.com/html/randg/ecs0126bk/ecs0126bk_fitting-instructions_3096606001.webp)
R&G
Unit 1, Shelleys Lane, East Worldham, Alton, Hampshire, GU34 3AQ, UK
Tel: +44 (0)870 220 6380 Fax: +44 (0)1420 521101
Email:
FITTING INSTRUCTIONS FOR ECS0126BK ENGINE CASE SLIDER
DUCATI PANIGALE V4, V4S & SPECIALE (LEFT HAND SIDE ONLY)
Please note that the way the kit is packed does not necessarily represent the way of mounting to the bike
Please note that in cases where kits are packed with rubber washers holding the components onto the bolt –
the rubber
washers should be thrown away
!
Left-hand side (as you sit on bike)
•
Remove two M6 bolts that hold the centre cover to the main casing as positioned above, leaving the cover in
place.
•
Insert new button head screws with washers through slider.
•
Offer up to bike.
•
Tighten evenly to manufacturer’s specified torque.
•
Fit bubble sticker as shown above.
CONSUMER NOTICE
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design
changes which do not diminish their performance or visual appeal and supplying them in such state shall conform to the order. The
Buyer acknowledges no representation or warranty (other than as to title) has been given or will apply to the Products other than those
in R&G’s order or confirmation and the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for
its particular purposes. Where R&G fits the Products or undertakes other services it shall exercise reasonable skill and care and rectify
any fault free of charge unless the workmanship has been disturbed. The Buyer is responsible for ensuring that the warranty on the
motorcycle is not affected by the fitting of the Products. On return of any defective Products R&G shall at its option either supply a
replacement or refund the purchase money but shall not be liable if the Products have been modified or used or maintained otherwise
than in accordance with R&G’s or manufacturer’s instructions and good engineering practice or if the defect arises from accident or
neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal injury, it shall not be
liable for indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the Products or
the fitting or service concerned. These terms do not affect the Buyer’s statutory rights.
R&G RETURNS POLICY (NON-FAULTY GOODS)
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were
purchased direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-
sellable condition, in the opinion of R&G. All returns are subject to a 25% restocking and handling fee (25% of the gross value exc.
P&P – at the prevailing price at time of purchase). The customer must pay any and all carriage charges. No returns of discontinued
products, unless within 14 days of purchase. This policy does not affect your statutory rights and does not refer to faulty goods.