HYOSUNG RT 125 D, Service Manual

Page: 72 / 94

71
ENGINE 3-48
5th
4th
3rd
2nd
N
Low
A A
A
A
A A
CAUTION
After the gear shift cam driven gear, gear shift
cam guide, gear shift shaft and neutral cam
stopper have been fitted, confirm that gear
change is normal while rotating the
countershaft and driveshaft. If gear change is
not obtained, it means that assembly of gears
or installation of gear shift fork is incorrect. If
this is the case, disassemble and trace the
mistake.
●
If a large resistance is felt to rotation, try to free
the shafts by tapping the driveshaft or
countershaft with a plastic hammer as shown in
the figure.
⊙ ⊙
GEAR SHIFT CAM DRIVEN
GEAR
● When installing the gear shift pawls into the gear
shift cam driven gear, the large shoulder
must
face to the outside as shown.
● Next, install the gear shift cam guide and gear
shift pawl lifter. Apply a small quantity of THREAD
LOCK
“
1324
”
to the threaded parts of the
securing screws.
THREAD LOCK “1324”
⊙ ⊙
GAER SHIFT SHAFT
When installing the gear shift shaft, match the center
teeth of the gear on the gear shift shaft with the
center teeth on the gear shift cam driven gear as
shown.
RIGHT END COMPONENTS
OF ENGINE REASSEMBLY