HYOSUNG COMET 650 FI, Owner'S Manual

Page: 68 / 90

67
1. Place the motorcycle on the jack or block.
2. Loosen the axle nut
①
.
3. Loosen the lock nut
②
.
4. Adjust the slack in the drive chain by
adjuster
③
as turning toward the left and
right.
5. For alignment of the rear sprocket and
the front sprocket, there are reference
mark
④
on the same position, right and
left.
After aligning and adjusting the slack in
the drive chain to 20 ~ 30 mm (0.79 ~
1.18 in), retighten the lock nut and axle
nut securely and perform a final inspec-
tion.
The drive chain for these motorcycles is
made of the special material.
The chain should be replaced with a
RK525XSO for .
Use of another chain may lead to prema-
ture chain failure.
CAUTION
The drive chain should be inspected
every time before riding.
Excessive chain slack could cause the
chain to come off the sprockets and
result in accident or serious engine
damage.
CAUTION
20 ~ 30 mm (0.79 ~ 1.18 in)
◉ ◉
DRIVE CHAIN CLEANING AND OILING
This drive chain has special “X-O rings”.
Clean and oil the chain periodically, as fol-
lows :
1. Clean the chain with kerosene. If the
chain tends to rust, the interval must be
shortened. Kerosene is a petroleum
product and will provide some lubrica-
tion as well as cleaning action.
Kerosene can be hazardous. Kerosene
is flammable. Children or pets may be
harmed from contact with kerosene.
Keep flames and smoking materials
away from kerosene. Keep children and
pets away from kerosene.
If swallowed, do induce vomiting. Call a
physician immediately.
Dispose of used kerosene properly.
WARNING
Be careful not to touch the muffler when
it is hot : a hot muffler can burn you.
WARNING
Cleaning the chain with gasoline or
commercial cleaning solvents can dam-
age “ X-O rings” and ruin the chain.
Clean the drive chain with kerosene
only.
CAUTION
Comet650 2008.7.11 3:40 PM ˘ ` 67 JINSUN 300DPI 100LPI T