hymer ERIBA Touring 2012, Instruction Manual

Page: 62 / 158

62
Touring - 04/11-1 - englisch (EN) - 2048869 - HYW-0102-09EN
6 Living
6.10.5 Rear seating group
„
Slightly raise the front of the table-top (Fig. 45,3).
„
Loosen the table leg (Fig. 45,6) out of the locking device and fold it against
the bottom of the table.
„
Lift the table-top by approx. 45°, remove it out of the mounting rail
(Fig. 45,4) and lay it aside. The table is not required for the sleeping con-
version.
„
Remove both seat cushions (Fig. 45,2) and lay them aside.
„
Remove both back cushions (Fig. 45,1) and lay them aside.
„
Remove the bed rods (Fig. 46,7) from the holder on the bedding box
(Fig. 46,5).
„
Fold up the seat bases (Fig. 46,8) and locate the bed rods (Fig. 46,7) in the
grooves horizontally between the two bedding boxes.
„
Fold both seat bases back down.
„
Fold down the upper section of the seat base (Fig. 46,8) towards the centre
of the vehicle on both sides and rest them on the bed rods.
„
Place the seat cushions (Fig. 47,2) in the centre.
„
Insert the back cushions (Fig. 47,1) between the seat cushions (Fig. 47,2)
and the exterior wall.
Fig. 45 Prior to conversion
Fig. 46 During conversion
Fig. 47 After conversion
1 Back cushion
2 Seat cushion
3 Table-top
4 Mounting rail
5 Bedding box
6 Table leg
7 Bed rod
8 Seat base