hymer ERIBA Touring 2012, Instruction Manual, Page: 121 / 158

121
Touring - 04/11-1 - englisch (EN) - 2048869 - HYW-0102-09EN
Customer service and maintenance 12
12.4 Replacing bulbs, external
The bulbs of the reverse light (right) (Fig. 101,1) and the fog tail light (left) are
replaced in the same way.
„
Press the lamp (Fig. 102,1) downwards against the resistance of the spring
(Fig. 103,2) and simultaneously pull the upper edge backwards.
„
Remove housing (Fig. 103,3).
„
Fold the clip (Fig. 103,1).
„
Remove bulb.
„
Insert new bulb and secure with clip.
„
Insert the housing with the holding lugs (Fig. 103,4) into the upper edge of
the lamp surround.
Z
It is not possible to reset the friction pads.
X
Bulbs and light fittings can be extremely hot. Therefore, allow lights to
cool down before changing bulbs.
X
Store bulbs in a safe place inaccessible to children.
X
Do not use any bulb that has been dropped or which shows scratches in
its glass. The bulb might burst.
Z
A new bulb should not be touched with the fingers. Use a cloth when
installing the new bulb.
Z
Only use bulbs of the same type and with the correct wattage.
Z
If LEDs in lights are defect, contact an authorised dealer or service centre.
Fig. 101 Rear lights
Fig. 102 Reverse light fitted Fig. 103 Reverse light removed