HygroMatik WL-ROL 160-1200 Series, Manual

Page: 8 / 76

Page 8
2. Safety Instructions
These safety instructions are required by law.
They promote workplace safety and accident
prevention.
2.1 Guidelines for Safe Opera-
tion
2.1.1 Scope
Comply with the accident prevention regula-
tion „DGUV Regulation 3“ to prevent injury to
yourself and others. Beyond that, national
regulations apply without restrictions. This
way you can protect yourself and others from
harm.
2.1.2 Unit control
Do not perform any work which compromises
the safety of the unit. Obey all safety instruc-
tions and warnings present on the unit.
In case of a malfunction or electrical power
disruption, switch off the unit immediately and
prevent a restart. Repair malfunctions
promptly.
Restricted use.
IEC 60335-1 stipulates as follows:
This device may be used by children of eight
years of age and above as well as by persons
with reduced physical, sensory or mental ca-
pabilities or lack of experience and knowledge
so long as they are supervised or have been
instructed regarding the safe use of the de-
vice and understand the hazards that may re-
sult from it. Cleaning and maintenance of the
unit must not be undertaken by children with-
out supervision.
The installation room must be adequately
ventilated and be equipped with a floor drain.
A water stop mechanism (e.g. leakage detec-
tor) can be used as an alternative.
2.1.3 Unit operation
Danger of scalding!
Hot surfaces can cause injuries. Protect
yourself with suitable protective equipment.
Water leaks possible due to defective con-
nections or malfunctions.
• Before starting work, the water supply
to the reverse osmosis system (RO
system) must be shut off.
• The system may be under pressure.
Release pressure before starting work.
• The reverse osmosis (RO) systems
continuously produce permeate (prod-
uct water) and concentrate (waste
water). Connections and water-carrying
components must be checked regularly
for correct functionality.
Risk of material damage!
• The unit may be damaged if switched
on repeatedly following a malfunction
without prior repair. Rectify defects
immediately!
• Regularly check that all safety and
monito-ring devices are functioning
normally. Do not remove or disable
safety devices.
It is essential to leave the RO system con-
nected to the power supply permanently.
Only then the automatic rinsing can be car-
ried out (protection against germs).
WARNING
!
NOTICE
NOTICE
NOTICE
NOTICE