Page 62
Blow-down cate-
gory (contd.)
62
Full blow-
down
The blow-down icon in the display is lit.
65
Max. level
Max. allowable water level in steam cylinder was
overrun.
66
Stand-by
blow-down
The blow-down icon in the display is lit.
67
Dead leg
flushing
Special blow-down mode for flushing dead leg tub-
ing. Solenoid valve and blow-down pump are acti-
vated simultanously in case of a no demand
situation for a certain period of time. The blow-down
icon in the display is lit.
80
Partial blow-
down waiting
Device will start partial blow-down with next filling
step.
81
Full blow-
down waiting
Device will start full blow-down with next filling step.
Service category
271
Service
steam
amount
The service threshold for the steam amount pro-
duced as preset in 3-3 (SI units) or 3-4 (imperial
units) was exceeded. The service icon in the display
is permanently lit for the time the message is active.
The status message may be reset by setting param-
eter 3-1 to „1“.
272
Service main
contactor K1
switching
cycles
The number of main contactor switching cycles pre-
defined by the manufactorer was met. A main con-
tactor replacement is advisable. The service icon in
the display is permanently lit for the time the mes-
sage is active. For resetting the status message,
parameter 3-2 must be set to „1“.
Fault category
999
Fault
A fault was detected. Operation has ceased. An
error code may be read out. Some certain faults
also make an icon in the display blink.
r02 Error
(only shown when a fault
has occured)
The error code related to the fault is displayed (steam production is
stopped whenever a fault occurs). Error codes are described in the
„Trouble shooting“ chapter of this manual.
r03 Actual steam output
(SI units)
Amount of current steam production value [kg/h]
r04 Actual steam output
(imperial units)
Amount of current steam production value [lb/h]
r05 fillig level
Indication of the water level in the cylinder [mm]
r07 Internal control sig-
nal
The internal signal for controlling the steam humidifier electrical
power delivery is displayed. [%]. This reading is influenced by the
control curve and a power limitation preset
Reading value
Explanation
