hyfire HFW-W2W-01, System Configuration Manual

Page: 41 / 302

www.acornfiresecurity.com
SECTION 2 (CONT)
INPUT/OUTPUT MODULE INDICATIONS
The Input & Output Modules have processes that can only be altered using the Wirelex software:
Supervisory circuits (Input Module):
a. Do not supervise tamper sensor: If the front cover of the module is removed and the
tamper switch is activated, this indication will not be passed to the Translator Module.
This process is default unchecked.
LED Indication:
a. Fire: If this indication is unchecked, the device LED will not indicate (glow RED) if there
is a fire activation signal received at the Input Module.
b. Battery Discharge: If this indication is unchecked, the device LED will not indicate
(glow RED) if there is a battery discharge signal received at the Input Module.
Supervisory circuits (Mains Powered Output Module):
a.
b.
Do not use front tamper: The Output Module has a front tamper spring fitted. If the
front cover is removed, the Output Module will pass a tamper fault to the Translator
Module and onward to the associated Fire Control Panel. This process is default
checked.
Do not supervise supply voltage: If there is a problem with the device power supply,
the device will forward a signal to the Translator Module and on to the associated Fire
Control Panel. The Output Module LED will flash RED with an interval of 0.1 seconds
ON/2 seconds OFF. This process is default unchecked.
The LED will illuminate ONLY if the "Low Power Supply" box is checked. This indication
is default checked.
The Output relay can be set at either "Normally closed" or "Normally Open" depending
on the operation required.
Supervisory circuits (Battery Powered Output Module):
a.
b.
c.
External fault input: If there is a short or open circuit, the child device will indicate this
to the Translator Module. This process is default checked.
LED Indication: If either the primary or secondary battery reaches a discharge state,
the device LED will illuminate either GREEN (secondary cell) or RED (primary cell).
The flash interval is 0.5 seconds ON / 0.5 seconds OFF. This process is default
checked.
Voltage output 12/24V: There is a selectable voltage output (12/24V) that is available
to the installer to power a stand-alone ancillary device. If the " To activate output" box is
unchecked, this option is not available. There is the option to have this as a constant
output or switching output.
The Output relay can be selected as a "Normally closed" or "Normally Open"
depending on the operation required.
NOTE: ALL THE ABOVE PARAMETERS CAN ONLY BE ALTERED USING THE WIRELEX
CONFIGURATION TOOL
WCTM Issue 3 Page 21 of 155