hyfire HFW-W2W-01, System Configuration Manual

Page: 19 / 302

www.acornfiresecurity.com
SECTION 1 (CONT.)
INSTALLATION
The HFW-W2W-01 Translator Module is relatively simple to install providing the recommended
procedures described in this Installation Guide are followed.
Follow all installation instructions described in this manual. These instructions must be
understood and the manufacturer's recommendations followed to avoid damage to the Fire
Control Panel and associated equipment.
CHECK THE TRANSLATOR MODULE / FIELD DEVICE FOR DAMAGE
Before attempting to install the Translator Module and field devices, you should do the following:
After removing the Translator Module/field device from its packaging, and
before you proceed with installing it in its chosen location, check for any
damage that may have occurred whilst in transit.
Note: In the unlikely event that the Translator Module/field device has
been damaged, then you MUST NOT fit it but return it to Sterling Safety
Systems. The procedure for returning faulty items is detailed in the
paragraph:
WHAT TO DO IF YOUR TRANSLATOR MODULE/FIELD DEVICE IS DAMAGED
ORSUSPECT
If you are satisfied that none of the supplied items have been damaged you
can now proceed with the installation procedure. This manual addresses
the recommended installation methods of the Translator
Module.
To prevent unnecessary damage to the electronic components, it is recommended that the electronics
are removed from the housing prior to fixing of the back-box. Refer to page 12 ( BACK BOX FIXING)
for details.
WHAT TO DO IF THE TRANSLATOR MODULE/FIELD DEVICE IS DAMAGED OR SUSPECT
If you have problems regarding the quality of the Translator Module/field devices, follow the procedure
below:
•
DO NOT continue with the installation but contact Sterling Safety Systems for
advice on what to do next.
•
Similarly, if the product is found to be faulty during installation contact Sterling
Safety Systems immediately.
To aid us, you are requested to:
a.
b.
c.
Quote the unique batch reference number which can be found on
packaging, main chassis or inside the back box.
With reference to PCBs, quote the part number and revision level
which can be found along one edge of the PCB.
Note all the details relevant to your complaint, date of receipt,
packaging condition, etc. and forward this to Notifier.
•
Where the product needs to be returned to Sterling Safety Systems, you are
requested to use the original packaging, or suitable anti-static equivalent,
wherever possible.
WCTM Issue 3 Page 10 of 155