hyfire HFW-W2W-01, System Configuration Manual

Page: 39 / 302

www.acornfiresecurity.com
SECTION 2 (CONT)
INDIVIDUAL CHILD DEVICE GUIDANCE
SENSORS
Sensitivity (Optical and Multi-criteria Detectors): The default sensitivity for the smoke channel is
" NORMAL". This can be altered to "LOW" or "HIGH" depending on the installation. This equates to an
obscuration value of 2% (Low); 3% (Normal); 4% (High).
Indications: The system allows the user to uncheck the indications for "FIRE" , "BATTERY
DISCHARGE" and "ALARM" . If these boxes are unchecked no report will be indicated at the
Translator Module and associated Fire Control Panel.
Send analogue values of smoke/temperature: If this box is unchecked, the analogue value for the
device will not be seen at the Translator Module and associated Fire Control Panel.
Smoke Channel (Multi-criteria Detector): This process can be isolated in this device if the Detector
is required to work with the Thermal Channel only
Thermo Channel (Thermal and Multi-criteria Detector): There are three modes of operation for this
parameter:
a.
b.
c.
Fixed - A standard "Fixed Temperature" Detector operating in the 58°C - 64°C zone.
Rate of Rise - A standard "Rate of Rise" Detector.
Fixed Rate of Rise - this is the default mode of operation.
This mode of operation should be used if the expected Rate of Rise of the Detector will
be too slow for the device to operate correctly. It is a combination of the first two modes
of operation.
The Thermal Channel can be disabled in the Multi-Criteria detector, by unchecking the
associated box, if the device is required to work with the Smoke Channel only.
MANUAL CALL POINT
NOTE: The depth of the Manual Call Point back box and the current design of the radio PCB
prohibits the use of the bottom right hand securing point of the Manual Call Point back-box
(when looking at the back box on the wall). If the securing point is used, the primary power
cell will be damaged and will cause the device to be potentially fatally damaged.
WCTM Issue 3 Page 20 of 155