hyfire HFW-W2W-01, System Configuration Manual

Page: 154 / 302

www.acornfiresecurity.com
SECTION 5 (cont)
The wireless Beacon has a tamper spring mounted on the device that will activate if the device
is removed from its base. If the tamper is activated, an indication is sent to the associated
Translator Module and ultimately to the Fire Control Panel. If there is a requirement to NOT
monitor this process, the check box
"Do not supervise tamper detector" should be checked.
The default state for this process is that the box is unchecked. It is recommended that this
process be left in the default state.
The "Supervisory Signal period" should be left at the default value of 7 seconds. If the
device quantity is > 1, only the first device address will appear in the parameter window but all
devices of the type selected will have the same operational parameters.
The "Supervision period" would normally be left unchanged. This can be changed from the
default "3 mins" by changing the level in the "Supervision period" window.
Un-checking the "LED Indication" box - "Battery discharge" - will stop the device
LED indicating if the batteries reach a discharge state. The default for this indication is to
remain checked and it is recommended that this indication be left in the default state.
On completion of parameter/process changing press .
The window will close and the user will be directed back to the "Configuration" tab for adding
further devices (if required).
WCTM Issue 3 Page 80 of 155