Hydrofarm ActiveAqua AACH100HP, Instructions Manual

Page: 15 / 16

15
INSTRUCTIONS
filter and housing. Clean the pre-filter as well if one is used.
3. Reconnect the pump to the chiller inflow tubing and place it in a clean reservoir.
4. Fill the reservoir with clean water and a flushing agent formulated to remove salt deposits and
excess nutrients from the plant system and grow medium (available at most indoor gardening
and hydroponic retailers). Note: Using a flushing agent is completely optional.
1. LOOSEN SCREW ON FRONT PANEL
2. GENTLY REMOVE FRONT PANEL
3. LOOSEN FILTER SCREWS
4. REMOVE FILTER 5. LIFT AND REMOVE SIDE PANEL
6. LOOSEN SCREEN ON SIDE PANEL
5. REMOVE FILTER
8. REMOVE DUST WITH BRUSH, VACUUM, OR RINSE
TROUBLESHOOTING
SYMPTOM CAUSE SOLUTION
The unit doesn’t run and
the display is blank
Power is not turned on Turn on the power
Plugged in incorrectly
Be sure the power cord is fully plugged
in
The unit cycles on and
off
Wrong voltage and/or frequency Apply to correct power source
Chiller is in protection mode
A. Check if the water circulation is
normal
B. If the fan and the chiller dissipate
heat normally, wait for 3 minutes and
the unit will automatically turn on
again
Performance is
decreased or there is no
refrigeration
Fan is not working Return to place of purchase
The set temperature is higher
than the aquarium water
temperature
Reset temperature
The air inlet or outlet are clogged
Clean the air inlet/outlet with a brush
or a vacuum cleaner
Loud operation Not installed on a flat surface Reinstall correctly