Hydro-Pro Inverter 07, User And Service Manual

Page: 22 / 176

- 18 -
TIME setting
Press first ,then press the to enter into “Current time “ displaying . Then press once again to
enter into “HOUR” setting. The “Hour “ flashes, and press the or to set the hour ,then press
to save the “Hour”. Then the “ Minute” flashes, and press the or to set the “Minute” and finally
press the to save the current time setting , or press for quick ‐ exit and saving.
Timer On setting:
The operation is the same to TIME setting after you entering into the ‘Time of automatic start’ interface.
Once done, the light will display.
Timer off setting:
The operation is the same to TIME setting after you entering into the ‘Time of automatic stop’ interface.
Once done, the light will display.
Cancel Timer ON/OFF
When you set Timer ON/OFF data 00:00, it means cancel the Timer ON/OFF function.
ATTENTION: Above operations, you could press to save the setting and quick ‐ exit the program.
* Noted:
* In order to heat the water in the pool (or hot tub), the filter pump must be running to cause the water to circulate
through the heat pump. The heat pump will not start up if the water is not circulating. If the water is not circulating
and the Heat Pump is ON the LED controller inform with the error code ON
* LED wire controller can operate the water pump after connected additional cable to the pump device in the
position of “PUMP” terminal accurately.
* When HP stop running in 30 seconds, water pump will shut off automatically
6.2.4 System reset function
Press and in 10s, the system will reset and display “0000” on the controller.
6.2.5
Symbol of heating, the light will be on when it is in operation.