HydraMaster Corporation
Page 4-2 : CTS 450 Owner’s Manual
CTS 450
Hot Carbonating Truckmount System
Engine Oil and Filter Change
1. Remove oil drain cap located on right center bottom
side of machine (
Figure 4-2
). Do not reinstall cap
until you begin filling the engine with oil (refer to step
4).
2 Remove oil filter located on the left side of
the engine.
3 Apply oil to the new oil filter gasket. Install oil
filter.
4 Remove the oil fill cap located on top of the
valve cover.
5 Begin filling engine with 30W. After the oil
begins to flow out of the oil drain fitting, re-
install the cap. This will allow air to evacuate
from the system and give accurate oil level
readings.
Failure to do this step will result in an insuf-
ficient amount of oil in the engine!
Engine oil
capacity is 3.5 quarts.
6 Check oil dipstick for proper level.
7 Re-install the oil fill cap.
Tools
11/16 inch wrench,
Oil filter wrench
Figure 4-2
CAUTION
!
Figure 4-3
Figure 4-4
Summary of Contents for CTS 450
Page 2: ......
