HDA 5500 for HLB 1000 and CS 1000
- 25 -
Use the
to change the setting
mode
mode
or
Press mode key
Release mode key
keys
Note:
•
If when pressing
or
Loc
appears in the display, this shows that programming is
disabled. To enable programming, see Point 12 Programming enable.
•
Hold down
or
to scroll quickly through the values in the display.
12 Programming enables
The unit has two types of programming enable, the operating programming enable and the
main programming enable. Both types must be enabled to change the settings.
The
operating programming enable
provides protection from unintentional changes to the
settings during normal operation. The operating programming enable can be altered during
operation.
The
main programming enable
provides general protection from changes to the settings.
The main programming enable can only be altered when switching on the HDA 5500.
12.1 Altering the operating programme enable
Procedure:
•
During normal operation, press the
and
keys simultaneously and hold down for at
least 3 s.
•
OPrG
(Operating Programming) is displayed.
•
After approximately 2 s the display changes and the actual setting is displayed:
Free
(programming enabled) or
Loc
(programming disabled).
•
Within approx. 3 s the setting can be changed to
Loc
or
Free
by pressing
or
.
•
If
or
is not pressed for approximately 3 s or longer, then the displayed setting is
accepted. If a setting has been altered, then
ProG
(programming) is displayed for
approximately 2 s. This means the changed setting is stored in the HDA 5500. Afterwards
the display returns to normal operation.
3 s
measured value
3 s
Press both arrow
keys simultaneously
and hold down for 3 s
Use
to change setting
Loc
FrEE
= programming disabled
= programming enabled
Display
(release
arrow keys)
2 s
mode
mode
or
Displays
