Hyd-Mech S-20H, Operations & Maintenance Manua

Page: 18 / 65

Pg 9
S22Hna 2002a
OPERATING INSTRUCTIONS
OPERATOR CONTROL PANEL
The operator control panel provides the operator with all the controls necessary to operate the saw after the
cutting angle has been set and the stock has been loaded and secured. All of the electrical functions are operated
from the control panel. The Vise and Feed Rate setting are both controled with the hydraulic controls shown on the
next page.
ELECTRICAL CONTROLS
HYDRAULIC BUTTON
This button will start the hydraulic
START Button, system. It will
illuminate when pressed and held
momentarily.
EMERGENCY STOP BUTTON
Pressing the red EMERGENCY STOP
Button STOP Button will turn OFF all
machine functions with the exception of
the coolant if the selector switch is in
the WASH position.
BLADE SWITCH
This selector switch starts and
stops the saw blade. The blade will
not start with the Head in the down
position.
COOLANT SWITCH
ON : Coolant flow when
blade is running.
OFF : No coolant flow.
WASH : Constant flow.
HEAD CONTROLS
UP The head will rise as long as the
lever is pushed up.
HOLD The head will stay at it's
current position when the lever is in this
position.
DOWN The Head will descend at set
Feed Rate.
FEED RATE DIAL The speed at which
the head will descend can be set on the
scale of 1 to 10. As the number
increases so does feed rate.
VISE CONTROL
OPEN The vise will open when
the lever is pushed up.
HOLD The vise will hold it's
position when the lever is in the
center position.
CLOSE The vise will close when
the lever is pushed down.
NOTE: See page 14 if the bundling
option is present.