Hyd-Mech S-20H, Operations & Maintenance Manua

Page: 12 / 65

Pg 5
S22Hce 2002a
LIFTING THE S-20 SERIES II
The S-20 is shipped with a shipping pallet attached
to the saw. When lifting the pallet with a forklift truck
make sure that the load is firmly balanced. The
following photo shows a lift truck lifting the saw and
pallet from the correct side. The pallet length dimension
is 87” (213cm). Minimum fork length of 72” (182cm) is
recommended to safely lift the pallet.
WRAPPED FOR SHIPPING
The S-20 Series II is shrink-wrapped for shipping
from our plant. Remove the wrapping from around the
saw. Complete the inspection for signs of damage. The
photo shows the floor mounting plates located at the
corners of the saw. Undo the bolts that hold the saw to the pallet. Retain
these bolts to use for levelling. The larger diameter hole is used for
retaining during shipping and for use with concrete floor anchors. The
smaller diameter, threaded holes at each corner are used for levelling the
saw properly.
REMOVING THE SAW FROM SHIPPING SKID
Lift the right (drive) side of the saw as shown with a lift truck and
place two blocks under the saw as shown. With a lift truck (fork
length 60” (150cm) and rated for 1800lb (810kg) minimum), lift the
saw from the skid at the FRONT of the machine as shown and place
it where required.
Lifting the packaged S-20 Series II with a lift truck.
Bolt holding the saw to the skid (4
places).
Blocks placed under the saw.
Lifting the machine with a lift truck from the front
of machine.