36
2) When Using in Dynamic IP DHCP Mode
1) Connect the network cable to the printer.
2) Turn on the power by setting Ethernet ON, and setting the IP Mode to Dynamic IP DHCP. The
printer starts protocol exchange communication with the host as the Error light blinks every 1
second. If connection is successful, the Error light stops blinking.
Connection attempt: Blinks at 1 second intervals.
Connection successful: Flashing stops and returns to print standby.
3) Turn off the printer.
4) Turn on the printer while pressing the FEED button.
Self-test printing is performed, and the IP address automatically acquired in DHCP Mode is
printed.
5) After checking the automatically acquired IP address, turn the power off and on, and the
printer will boot up with this automatically acquired value, and applications can communicate with
this value.
When booting in Dynamic IP DHCP Mode, the automatically acquired communication
parameter values may change every time, so special attention is required.
CAUTION
www.compodis.com
