Huvema 19002, Manual

Page: 30 / 53

29
9-7 TROUBLE SHOOTING HINTS
TROUBLE SHOOTING HINTS
TROUBLE PROBABLE CAUSE REMEDY
No action when Push
running
1. Belt break or weared
2. Bad motor
3. Relay failure due to
over-load
1. Replace belt
2. Replace motor
3. Reduce feed
rate/sharpen tool and
keep sharp
Motor Stalls
1. Over feeding
2. Dull cutting tools
3. Motor not building to
running speed
4. Bad motor
5. Belt weared
1. Reduce feed rate
2. Sharpen tool and keep
sharp
3. Replace or repair motor.
Check fuses in three legs
on three phase motors
and replace if necessary
4. Replace motor
5. Replace new belt
Work for fixture
comes loose
1. Failure to clamp
workpiece or work
holding to table.
2. Failure to clamp
slotting bar.
1. Clamp workpiece or
work holding device to
chuck or table.
2. Clamp Slotting bar.