Husqvarna PG 680 RC, Operator'S Manual

Page: 35 / 204

STARTING AND STOPPING
English
–
35
Start (remote maneuvering)
• Make sure the machine stop on the remote control is
not depressed by turning it clockwise.
• Make sure the STOP/RUN control on the remote
control is turned to STOP.
• Turn the main switch to position '1' to start the
machine. Turn the switch on the control panel to '0' for
remote operation. Start the grinding unit by turning the
STOP/RUN switch on the remote control to RUN. The
grinding unit will then start smoothly and accelerate to
the set speed within 5 seconds. During the boot, it is
default for the small engine to have about 2 sec. delay.
• When starting on abrasive surfaces it may be
necessary to apply a small amount of forward
pressure on the joystick to release the surface friction
of the diamond tools.
Stop (remote maneuvering)
• Turn the STOP/RUN switch to STOP. Continue
keeping the machine in motion with the control lever
until the grinding unit stops.
!
CAUTION! Make sure the locking pins in
both wheels are depressed so that the
wheels are engaged for remote
maneuvering.
NOTICE! Never leave the machine unattended while
grinding.