2. Move the depth stop to desired position as shown in
the image.
14”
(355,6mm) (508mm)
20”
(609,6mm)
24”
14”
20”
24”
0
3. Tighten the locking nuts for the depth adjustment.
4. Mount correct blade size in relation to the depth stop
setting.
5. Check the position of the blade by moving the
conveyor cart to its forward and rear end position.
The blade should never hit the cart.
To center the blade in the cutting slot
1. Set the blade to run freely and in its lowest position
in the cutting slot.
2. Use a set square and check if the blade is
perpendicular.
3. Examine front and back edge of the blade to the
conveyor cart anvil.
4. Examine if the blade is centered in the cutting slot.
Operation
Introduction
WARNING: Never use a diamond blade to
cut plastic material. Cutting metal generates
sparks that may cause fire. Do not use the
product near ignitable substances or gases.
CAUTION: Under all circumstances avoid
grinding using the side of the blade; it will
almost certainly be damaged or break and
can cause immense damage. Only use the
cutting section.
Experience is very important when running the product.
A skilled worker is highly recommended.
• Do not overload the product. Overloading can
damage the product.
• If you are uncertain of what blade to use contact
your local service dealer.
• Never leave the product unsupervised with the motor
running.
• Keep tools sharp and clean in order to enable safer
work.
• Check that the blade is fitted correctly and does not
show signs of damage. See section
Assembly on
page 10
for instructions.
• Check that the correct blade is used for the
application in question.
• Never cut asbestos materials!
Before starting
• Please read the operator’s manual carefully and
make sure you understand the instructions before
using the product.
• Wear personal protective equipment, see
Personal
protective equipment on page 8
for instructions.
• Check that the fuel cap is properly secured, and that
there is no fuel leakage.
• Make sure no unauthorized persons are in the
working area, otherwise there is a risk of serious
personal injury.
• Prevent unintentional starting.Ensure the switch is in
the OFF-position.
• The cutting blade rotates when the engine is started.
Make sure it can rotate freely.
12
271 - 002 - 12.06.2018
Summary of Contents for MS 610
Page 3: ...Product overview MS 610 G 271 002 12 06 2018 3 ...
Page 25: ...Présentation du produit MS 610 G 271 002 12 06 2018 25 ...
Page 49: ...Descripción general MS 610 G 271 002 12 06 2018 49 ...
Page 72: ...Original instructions Instructions d origine Instrucciones originales 1158948 49 2018 06 25 ...
