17 ENGINE
-
Change the sliding plate.
-
Preassemble the shift shaft. (
�
p. 161)
-
Check clearance
O
between the sliding plate and the shift quadrant.
161
Shift shaft - sliding plate/shift quad
rant clearance
0.40 ... 0.80 mm (0.0157 ... 0.0315 in)
17.4.35 Preassembling the shift shaft
305010-10
If the measured value does not meet specifications:
-
Change the sliding plate.
-
Secure the short end of the shift shaft in the bench vise.
Guideline
I
Use soft jaws.
-
Mount sliding plate
O
with the guide pin facing downward and put the guide pin
on the shift quadrant.
-
Mount pressure spring
@.
-
Slide on spring guide
@),
push return spring
C,,
with the offset end facing
upward, over the spring guide and lift the offset end over abutment bolt
@).
-
Mount washer (D.
17.4.36 Disassembling the main shaft
306556-10
-
Secure the main shaft with the toothed end facing downward in the bench vise.
Guideline
Use soft jaws.
-
Remove stop disk
O
and second-gear fixed gear
@.
-
Remove fourth-gear idler gear
@)
and needle bearing
C,.
-
Remove stop disk
0.
-
Remove lock ring (D.
-
Remove third-gear sliding gear@.
-
Remove lock ring
fD.
-
Remove stop disk
@).
-
Remove fifth-gear idler gear G).