Husqvarna 525HE3, Operator'S Manual

Page: 12 / 80

2. Clean the area around the fuel tank cap.
3. Shake the container and make sure that
the fuel is fully mixed.
4. Remove the fuel tank cap slowly to release
the pressure.
5. Fill the fuel tank.
CAUTION:
Make sure that
there is not too much fuel in the
fuel tank. The fuel expands when
it becomes hot.
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the
product.
8. Move the product 3 m/10 ft or more away
from the refueling area and fuel source
before you start the engine.
Note:
To see where the fuel tank is on your
product, refer to
Product overview on page 2
.
To start the engine
WARNING:
Keep a minimum
distance of 15 m/50 ft from persons
or animals when you start the
product. There is a risk that the
cutting attachment starts to move.
1. Set the choke control in the choke position.
2. Push the air purge bulb until the bulb starts
to fill with fuel.
Note:
It is not necessary to fill the air
purge bulb fully.
3. Hold the body of the product on the ground
with your left hand. Do not put your feet on
the product.
4. Pull the starter rope handle slowly until you
feel some resistance, then pull the starter
rope handle with force.
WARNING:
Do not wind the
starter rope around your hand.
5. Continue to pull the starter rope handle
until the engine starts.
CAUTION:
Do not pull the
starter rope to full extension and
do not let go of the starter rope
handle. Release the starter rope
slowly to prevent damage to the
product.
6. When the engine starts, put the choke
control in the run position and apply full
throttle. The throttle trigger automatically
disengages from the start position.
7. Make sure that the engine operates
smoothly.
12 1173 - 001 -