Husqvarna 520iHE3, Workshop Manual

Page: 33 / 59

33 – English
Repair Instructions
5
Refers to cabling side.
Loosen the clamp (1).
Loosen the bushing (2).
Take care not to damage the cabling.
6
Dismantle the screws holding the upper angle joint
cover, 5 pcs.
7
Dismantle the screw holding the locking pin for the
angular adjustment of the cutting unit.
8
Work the cabling, one wire at a time, through the
angle joint.
NB! Exercise care so that the cabling is not
damaged.
Remove the lower angle joint cover.
9
Remove the locking pin retainer from the cabling.
The tape holds the locking pin retainer in place on
the cabling.
10
If the cabling is whole and intact, assemble the
locking pin onto the cabling. The tape on the ca-
bling is the locking pin retainer positioning.
2
1