Husqvarna 325HDA, Workshop Manual

Page: 19 / 40

19
5
504 90 00-02
4 mm
Remove the two screws. Counter hold
on the axle’s spanner flats.
Remove the housing from the shaft.
Remove the circlip (locking washer) on
the cog wheel in the angle gear.
Remove the circlip and bearing from
the pinion, if necessary.
Remove the outer circlip on the pinion
from the housing for the shaft.
Remove the pinion from the housing
for the shaft.
Use small circlip pliers for the axle and
puller 504 90 90-01.
Heat using a hot air gun to approx.
125
°
C and knock against a wooden
surface.
Remove the axle and crown wheel from
the angle gear.
Gear
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com