Husqvarna 325HDA, Workshop Manual

Page: 39 / 40

39
504 90 00-04
3 mm
504 90 00-02
4 mm
9
Check that the ignition cable is routed
correctly so it cannot be damaged by
the flywheel.
NOTE!
Risk for incorrect assembly.
If the wrong screw is placed in the
hole closest to the gearbox the
threads in the clip set will be crossed.
Fit the cylinder cover.
Align the cylinder cover with the slot for
the screw head, make sure that when
the cover is moved down that the
ignition cable is secured by the wedge
shaped cut-out in the cylinder cover.
Fit the thick threaded screw (for the clip
set) in the hole closest to the gearbox.
Fit the remaining screws for the
cylinder cover and tighten the screws
on the starter, heat guard and cylinder
cover.
Changing the front
springs
325HS75, 325HS99:
Remove the 3 screws holding the
springs in the frame and wear plate.
Unscrew the spring from the gearbox.
Replace the front support spring.
Remove the screw located in the wear
plate.
Remove the screw located in the frame.
Changing the rear
springs
325HS75, 325HS99:
Remove the 3 screws holding the
springs in the frame and wear plate.
Remove the 2 screws holding the rear
springs in the gearbox.
Slide the frame backwards so you can
gain access to remove the 2 screws
holding the springs on the frame.
Use pipe grips on the first spring turn
when removing the spring otherwise
the spring will self-lock in the
mounting.
Cutting equipment
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com