Husqvarna 325HDA, Workshop Manual

Page: 23 / 40

23
504 90 00-02
4 mm
503 98 96-01
5
Fit the bearing with circlip on the
pinion.
Fit the pinion with bearing in the
housing for the shaft.
Heat the housing with a hot air gun.
Press in the pinion to the stop and fit
the outer circlip.
Use a new circlip and make sure it is
not deformed when positioning. Make
sure the circlip has a good grip. Fit the cog wheel and a new circlip on
the axle to the gearbox.
Fit the axle with crown wheel in the
angle gear.
Fit the housing for the shaft.
Two screws with washers. Counter
hold on the axle’s spanner flats.
Fill the angle gear 2/3 with grease
503 98 96-01.
Fit the cover on the angle gear.
Turn the cover with the cut-out facing
towards the housing for the shaft.
Gear
For Husqvarna Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com