WORK
7
100410-11
–
Lift the front wheel into the fork, position it, and insert the wheel spindle.
–
Mount and tighten screw
.
Guideline
Screw, front wheel spindle
M24x1.5
45 Nm
(33.2 lbf ft)
–
Operate the hand brake lever several times until the brake pads are lying correctly
on the brake disc.
–
Remove the motorcycle from the work stand.
–
Pull the front wheel brake and push down hard on the fork several times to align
the fork legs.
–
Fully tighten screw
.
Guideline
Screw, fork stub
M8
15 Nm
(11.1 lbf ft)
3.4
Installing the engine guard
100450-10
–
Attach the engine guard on the frame at the rear and swing it up and forward.
Mount and tighten screw
.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
3.5
Removing the seat
100362-10
–
Pull on the loop
while raising the rear of the seat.
–
Pull the seat back and lift it off.
3.6
Mounting the seat
400514-10
–
Attach the seat to the hooks on fuel tank
and on the top part of subframe
,
and lower it at the rear while pushing forward.
–
Guide lock bolt
into the lock housing and push down the rear of the seat until
the lock bolt engages audibly.
–
Finally, check that the seat is correctly mounted.
