18
When Screw Stops during Operation
Caution in Using Power Dial
1
2
Note
If the screw still does not turn after following said directions, unplug the power cord, disassemble
chamber set, clean the parts, and try again.
To run in the reverse direction during extraction, turn the dial to [ ] to stop the
juicer completely and then turn to [REV] to run in the reverse direction. Due to the
design of the motor, it will not stop instantly,
but will slow down to a complete stop in the direction it was rotating.
The reverse action is active only when the power dial is held in [REV] position.
Note
Turn the power dial to [REV] for
3~5 seconds (counterclockwise)
and stop and repeat this twice or
three times.
The reverse rotation releases
ingredients tangled inside the
chamber. The reverse option is
active only when you hold the dial
in the reverse position and the
screw will stop when you release
the dial.
After the reverse motion
stops completely, turn the
power dial to [ON]
(clockwise) to run the juicer.
When you turn the dial to [ON]
or [REV], make sure the screw
comes to a complete stop and
then turn the dial to the direction
you want.
