14
1
3
5
2
4
How to Use
Assemble the mixing bar, prepare ingredients
according to their characteristics, and insert them
into the hopper.
Check the [MAX] and [ ] icons on the side
of the hopper and make sure the ingredients in the
hopper do not exceed that line.
Putting an excessive amount of ingredients can
strain the juicer.
Insert the prepared ingredients and close
the lid.
Turn the power dial to [ON] (clockwise).
After extraction, turn the power dial to [ ]
(counterclockwise) to stop the juicer.
Set the lever to [ CLOSE ] before
extraction.
Set the lever to Half Open [ ] when all
ingredients go down through the chamber
set.
Set the lever to [ ] (Half Open) when all
ingredients go down through the chamber set
and operate until no more pulp comes out of the
juicer.
For safety, the main body does not operate by
itself. It will only operate when it is properly
assembled with the chamber set.
Note
When turning the dial to [ON] or [REV], turn it only after
the screw stops completely.
The chamber may not be assembled onto the
main body if the control lever is not in CLOSE
[
CLOSE
] position.
For performance and safety, the juicer will not
stop instantly but slow down to a stop when the
dial is turned.
◑
◑
Smart Hopper
