12
Ingredients which needs caution.
It may cause damage or failure.
- For fruits with hard seeds such as mango, persimmon, peach, plum, cherry etc. that are too hard to
chew, the seeds should be removed before extraction.
- Cut stalk vegetables with tough fibers such as water parsley and celery to approximately 3cm in size
before extraction. If you do not prepare the ingredients properly, the juicer might stop or the ingredients
might coil around the mixing bar.
- Do not put in sesame seeds, coffee beans, tree barks, Chinese pepper, and so on that cannot be extracted.
- Do not put in fruits preserved in alcohol, sugar, honey, etc. (grapes, apricot, berries, etc.)
and enzymes (glasswort, houseleek, etc.). It may cause damage or failure.
- Do not insert ingredients that cannot be extracted due to their characteristics, such as figs, aloe, cactus
and ginger. It may cause damage or failure.
[Smart Hopper Only]
Soft ingredients such as banana and mango might pile up inside or would
not produce much juice if they are extracted by themselves. Extract with solid ingredients or
watery ingredients.
[Dual Hopper Only]
Extracting materials containing a lot of fibers such as ginger in a large
amount can cause breakage or malfunction. Ginger can be extracted only when using the dual
hopper.
We recommend you to drink green vegetable juice and fruit juice immediately after extraction
rather than keeping them for long time.
If you are extracting continuously, empty the pulp cup before continuing.
The pulp can run over.
- If the parts are not assembled properly, the juicer may not operate or it can cause breakage.
When the chamber stops due to overload, turning the power dial to [ REV ] can open the hopper.
- This is a safety mechanism designed to protect the product from damage and is normal.
You may use the appliance for crushing spices (garlic, red pepper), but not for grinding grains.
(It may cause damage or failure. )
Do not re-squeeze pulp discharged through the pulp outlet. Soft fruits can be re-squeezed.
Do not operate the appliance without ingredients inside.
It may cause a failure due to the overheating of the motor.
- When using the appliance continuously, stop for 5 minutes after every 30 minutes of use.
Never insert chopsticks or spoon into pulp outlet during the operation.
- Inserting such as chopsticks etc. into Pulp outlet during operation may cause them to stuck into the
spinning brush and cause damage to the parts.
It is possible that the hopper would not open easily due to the pressure inside the chamber after
extraction.
- Refer to Finishing Mode in p. 16 to discharge remaining pulp. The hopper will open easily
afterwards.
Do not operate the power dial with a wet hand
- It can cause electric shock, short circuit, or fire. Do not stain the power dial and its proximity with
alien substances.
Cautions during Operation
