19
Cleaning Parts
How to Clean
After the extraction, remove the pulp remaining inside
the chamber by referring to p. 13 (Finishing Mode)
before washing.
After the juicer comes to a complete stop, pull out the
power cord with a dry hand.
Move the chamber set by holding the chamber and the
hopper’s handle with both hands.
Disassemble the chamber set and wash the parts in
running water using the cleaning brush.
Set the lever to [OPEN ] and open the juice cap to
wash the chamber.
The intermediate gear inside the chamber can be
removed for washing.
Silicon packings can be also separated for washing.
(Juice Cap Packing, Silicon Brush)
Soak in the mixture of water, baking soda, citric acid, or
vinegar for 30 minutes for sterilization.
Clean the main body with dried towel or soft cloth.
01
02
03
04
05
06
07
08
09
Note
If the unit is not cleaned immediately after use, the pulp may dry and stick to the unit.
This will make disassembling and cleaning difficult and may also lead to performance
degradation. Do not wash with hot or boiling water, an iron scrubber, abrasive material, sink
solvents, or sharp cleaning tools. Do not put it in a dishwasher or dish dryer. After washing,
thoroughly and naturally dry, and store in a clean area.
◯
