Operation
Chapter 5
Adjustment of the open Tray Dispensers
Page 25
Tray dispenser
4330041_A2
OTA/47
–
36 | OTA/53
–
37 | OTA/58-33 | OTA/53
–
37 S | OTA/U-BW | OTA-E/BA-4xGN | TAG-1/53-37 | TA-2/53-37 | EBS-T/53-37
§
Tighten the setscrews and secure with the counter nuts.
§
Set up the appliance again, so that it stands on all four wheels.
Adjusting the upper attaching point
To adjust the height of the dishwasher, the upper attaching point of the stacking platform can be set continu-
ously between 27.5 and 19.6'' (700 and 500 mm).
Figure 13
Adjust stop point
To adjust the upper attaching point, proceed as follows:
§
Remove the three screws (1) on the front and back of the cover of the spring case.
§
Pull out the frontal sheet with plastic stop beads.
§
Remove the cover of the spring case. The push bars remain on the cover of the spring case.
The height of the upper attaching point or the upper spring suspension is adjusted with two threaded rods
according to the spindle principle.
Turns to the right shift the attaching point downwards, turns to the left shift the attaching point upwards.
Figure 14
Heads of the threaded rods
§
Turn both heads of the threaded rods (2) until the desired position of the upper stop is reached.
Therefore use an open-end wrench SW 17.
NOTE
Uniform rotation
Pay attention to uniform rotations, as the chassis of the stacking platform can
get twisted.
§
Put on the cover of the spring case.
§
Put the frontal sheet into the embedded folding of the sheet.
§
Insert the screws and tighten the cover of the spring case.
