Safety Instructions
Chapter 2
Safety Instructions for Cleaning and Care
Page 11
Mobile bain marie
4330036_A1
SPA/K-2DW | SPA/K-3DW
2.5
Safety Instructions for Cleaning and Care
The following points must be observed when carrying out any cleaning and maintenance operations:
§
The cleaning instructions must be strictly observed for reasons of hygiene.
§
Take the appliance out of operation before starting the cleaning process. Pull out the mains plug and
insert it into the holder located on the appliance.
§
Never flood the appliance with water for cleaning purposes. There is danger to life, when the appli-
ance is reconnected to the mains.
§
Do not clean the appliance with steam-jet or high-pressure washers. The appliance must be taken out
of operation and switched off at the mains beforehand in any area where steam-jet or high-pressure
washers are to be used.
§
Do not tilt the appliance for cleaning. If this cannot be avoided, keep it in a vertical position for two
hours before putting it into operation, so that the coolant can flow back into its initial position.
2.6
Safety Instructions for Troubleshooting
The following points shall be observed when carrying out any maintenance and troubleshooting operations:
§
The local applicable Accident Prevention Regulations must be observed.
§
Take the mobile bain marie out of operation, switch it off, pull out the mains plug and secure it against
unauthorised reactivation before performing maintenance or troubleshooting operations. When work-
ing on the electrical installation, the appliance must be switched off at the mains and secured against
reactivation. This work must only be carried out by an electrician.
§
Observe the valid product safety regulations for the product when handling oils, greases and other
chemical substances.
§
Carry out all the checks and inspections of the appliance on a regular basis. Remedy immediately de-
ficiencies, such as loose screw connections or damaged connecting leads.
§
Only authorised specialists may perform all repair work.
§
Only use original spare parts to replace defective components.
§
Do not tilt the appliance for troubleshooting. If this cannot be avoided, keep it in a vertical position for
two hours before putting it into operation, so that the coolant can flow back into its initial position.
2.7
Notes on Specific Hazards
Electrical energy
§
All work on the electrical installations should only be carried out by an electrician or by authorised
specialists under supervision and monitoring of a certified electrician according to the applicable elec-
tro-technical regulations.
§
The appliances on which inspection, maintenance and troubleshooting work is performed must be
disconnected from the power supply and secured against reactivation when voltage is not required for
this kind of work. This must only be carried out by an electrician.
