Huntleigh Flowtron AC550, Service Manual

Page: 37 / 42

5.14 Buzzer Replacement
Disconnect connector CON1. Cut wires from existing buzzer mounted on base.
Fit replacement buzzer onto a clear base area close to the front of the pump
ensuring that the lead is able to reach and fit onto CON1 .
Use Cyanoacrylate 495 adhesive to bond the sounder’s copper side to the plastic
case.
Ensure the sounder is firmly attached by applying pressure for 10 seconds.
Note: Sounder clarity and volume are dependant on the quality of this bonding
so ensure sounder output is checked by forcing the pump into a fault condition
in order to check sounder output.
5.15 Hang Strap Assembly
Place the unit upside down on a flat, clean surface. Unscrew and remove two
retaining screws from the hang strap plates anchoring the assembly to the base
of the pump unit. Lift the assembly away from the unit and replace it.
247901 5-7 Issue 1
March 1998