INSTALLATION
17
■
Mark the screw holes.
■
Drill the screw holes using a
3
⁄
32
" drill bit.
■
Attach the battery mount using the screws provided.
CAUTION:
Only use the screws provided with the battery mount, designed so that the
screws will install flush with the mount. Protrusion of the screws could result in either the
battery wand not attaching properly causing a failure to connect, or the wand falling out
of the mount. Do not over-tighten.
■
Connect the power cable from the motor side into the power socket on the rechargeable
battery mount.
NOTE:
With longer cables, wire retainers (not provided) are recommended to secure
the cable.
Insert the Battery Wand into the Battery Mount
NOTE:
The rechargeable battery wand ships fully charged, so it is ready to install out of the
package.
■
Match the direction of the arrow on the underside of the battery wand with the arrow on
the battery mount.
■
Insert the nose of the
battery wand into the
cavity of the mount
(the side plugged into
the blind).
■
Push the battery wand
flush into the mount
until the battery snaps into place.
CAUTION:
Failing to insert the wand properly may cause it to fall out of the mount,
posing an injury risk and potentially damaging the wand. Additionally, when mounting on
a door, closing the door with excess force may cause the battery wand to dislodge from
the mount, also posing an injury risk and possibly damaging the wand.
Proceed to “Testing the Blind” on page 20.
Battery Mount
Extension
Cable
(If Needed)
Power Cable
from Blind
Summary of Contents for EverWood
Page 34: ...CHILD SAFETY 32 ...
